The CP 5613 A2 is a communications processor for connecting PCs to PROFIBUS. The essential characteristics are as follows: ● The CP 5613 A2 is equipped with a PROFIBUS interface allowing up to 12 Mbps. It is intended for operation in PGs and PCs with a PCI bus interface according to the PCI standard V2.2. ● With the CP 5613 A2, up to 32 devices (PC, PG, SIMATIC S7 or ET 200) can be linked to form a network segment. By linking several segments with repeaters, a maximum of 124 nodes can be connected. ● Optimized for fast DP master operation (DP Base) with up to 124 DP slaves with full data consistency ● As an alternative, can also be used as a DP slave ● Relieves the PC due to event mechanisms (automatic detection of data changes) ● Fast logic support regardless of the user program (automatic linking of input and output data can be set by the user program). ● Plug and play support during installation of the hardware ● Support of all data transmission speeds from 9.6 kbps to 12 Mbps ● Floating RS-485 connector ● Support of PCI 3.3 V/5 V, 33 MHz/66 MHz, 32 bit/64 bit and PCI-X 66 MHz, 32 bit/64 bit

A DeltaV SE4305T01 IS DI NAMUR CHARM Communications Adapter with model number SE4305T01 has been detected. It is described by Emerson as an IS (intrinsically safe) Digital Input Characterization Module (CHARM) designed for NAMUR sensors.

Control Mode Open-loop vector or V/Hz induction motor control Open-loop Rotor Flux Control for induction motors (RFC-A) Open-loop permanent magnet motor control (RFC-S) Closed-loop Rotor Flux Control for induction motors (RFC-A) Closed-loop permanent magnet motor control (RFC-S) Active Front End (AFE) power quality convertor